New Features

The latest release of myCNC software brings improvements to filter out unwanted signals on common inputs, as well as signals sent from the operator panel. These settings can be found by going into Settings> Config> Hardware> Common Hardware Settings within the myCNC application:

The maximum delay limit on the filter is currently set to 250ms on the input pins filter. and to 10000ms (10 seconds) on the keyboard filter. This means that in order to have the controller register the input from its input ports or its keyboard panel, the signal must be repeated (button held, or key pressed) for a specified amount of time. This should allow  to mitigate electrical noise and accidental presses which would otherwise interrupt the workflow.

Bug Fixes

The Report tab is now showing correctly the number of pierce times, the tool path length and the total cut length:

Stay tuned for more updates!